Euro Kitchen Appliances PS29 Installationsanleitung

Installation Guide and Users ManualWall Mount Range HoodPS29/PS31IMPORTANT:Read and save these instructions.NOTICE:Installer: Leave this guide with th

IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualied electrician for 220-Volt 50 Hz voltage)It is the customer’s res

Page 9PreparationAdvanced Preparations:Be familiar with the controls of the range hood by reading through • Range Hood Operations, Page 12.Place the

Installations (refer to Page 4 for parts):Measure the distance between stove top and the bottom of range hood. A distance of 27” to 30” is recommended

Figure 8Page 11Installation (Continued)Connect the range hood to a designated standard outlet (please re-7. fer the product label for the suitable vol

Page 12Range Hood OperationsControl Panel Layout and Buttons Congurations:In addition to the remote control feature, this range hood is also equipped

Page 13Range Hood Operations (Continued)Control Panel Layout and Buttons Congurations:Activating Light Function: • Press Light button once to turn

TroubleshootingPage 14If the range hood or halogen light does not operate 1. after installation:Check if the range hood has been plugged in, make • su

Use and Care InformationOperations:Read and understand all instructions and warnings in this manual before operating the appliance. Save these • instr

Measurements and DiagramsInstallation Overview:CDUpper support frameRange hoodRound duct (exhaust)Chimney-mounting bracketAAir Movement DirectionUpper

All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measurements are estimated.• Overa

Page 18Overall without Chiminey:All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch me

Page 19Circuit Diagram:Hood-mounting Bracket:9-11/16” (246)9” (230)4-3/4” (120)

Page 20Range Hood Assembly:No. Description Quantity1 Hood-Mounting Bracket 12 Hood Body 13 Light 24 Control Panel 15 Oil Tunnel 16 Blow Assembly (Moto

Page 21Blower Assembly:No. Description No. Description1 Motor 4 Locknut2 Spuirrel Cage 5 Protective Grill3 Fan Blade

Page 22WARNINGHazard of Burns!Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching

Page 23One Year Parts Warranty:For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replac

Page 24Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and si

Your NotesPage 25

Manufactured forEuro Kitchen Appliances Inc.Burnaby ,BC , Canadawww.KitchenHoods.catel. 604 430 5252

Important Safety NoticeRead all Instructions before Installing and operating this applianceThe installation in this manual is intended for qualied in

Page 2Important Safety NoticeRead all Instructions before Installing and operating this applianceWARNINGYour safety and the safety of others is very i

Table of ContentsINSTALLATIONTools needed...3Parts supplied...

Page 4Parts supplied:Qty: 4 PCS(For sheet rock only)Qty: 2 PCS (30-in models)Qty: 3 PCS (36-in models)Chimney-mounting BracketQty: 6 PCSQty: 4 PCSQty:

Venting RequirementsPage 5Height & ClearanceVent system must terminate to the outside • (roof or side wall).DO NOT terminate the vent system

Page 6IMPORTANT:A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate-• ly) must be used to maintai

Venting MethodsPage 7This range hood is factory set for venting through the roof or wall.• Vent work can terminate either through the roof or wall. To